This was my first attempt at cutting the inlay and the channel with the MicroFence. The inlay is a piece of Lacewood bound by Macassar Ebony inside and out....tell me what you think.
Greg
| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Rosette With MicroFence(Pics) http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=5446 |
Page 1 of 1 |
| Author: | GregG [ Sat Mar 04, 2006 7:33 am ] |
| Post subject: | |
This was my first attempt at cutting the inlay and the channel with the MicroFence. The inlay is a piece of Lacewood bound by Macassar Ebony inside and out....tell me what you think. Greg
|
|
| Author: | Shawn [ Sat Mar 04, 2006 9:08 am ] |
| Post subject: | |
Looks great...it is nice to have a tool that is precise. Did you set the stops so that you could repeat those cuts on the next rosette? |
|
| Author: | GregG [ Sat Mar 04, 2006 9:21 am ] |
| Post subject: | |
I don't have the stops, I think they are add-on products, I will get them though that is for sure. Greg |
|
| Author: | Bruce Dickey [ Sat Mar 04, 2006 1:24 pm ] |
| Post subject: | |
Very nice. Looks very professional. |
|
| Author: | BlueSpirit [ Sat Mar 04, 2006 1:42 pm ] |
| Post subject: | |
That's some fine work. I'll have to look into this Micro-fence |
|
| Author: | Dave Anderson [ Sat Mar 04, 2006 2:19 pm ] |
| Post subject: | |
Very nice job on the rosette. I like the single black purf. |
|
| Author: | Brock Poling [ Sat Mar 04, 2006 2:19 pm ] |
| Post subject: | |
Check out this thread. About 2/3 of the way doen Sylvan lays out exactly what he did to set this thing up. http://www.luthiersforum.com/forum/forum_posts.asp?TID=1136& KW=micro+fence+sylvan#forumTop |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|